Network cable tester.
STP, UTP cable testing.
PoE scanning and PSE type identification.
Digital / analog signal testing.
Measure the cable length and fault distance.
For use with IEEE 802.3af / at and non-standard PoE switch (5~60V). Identifies AT or AF standards of PSE type.
LED backlight: the emitter and the receiver have a backlight function, convenient for working in dark environments.
Built-in NCV included in the receiver.
Cable continuity scan: tests open, short, cross etc. for STP, UTP cables, wiremap, fault location.
Cable length setting: measures LAN cable length, range: 2.5 m ~ 200 m.
PoE testing: POE voltage, power supply polarity, power supply mode, PSE type indicators.
Flash function - locates the target network port by the flashing port light on switch/ router. Displays connected switch’s information: network speed and protocol etc.
Test cable type: CAT5e / CAT6a / CAT6 (STP + UTP).
Power supply: battery 6R22, 9V (not included) and AAA batteries x3 (not included).
Max range (wiremap and scan): 600m.
Cable length test range: 2.5 m ~ 200 m.
Cable length accuracy: +/- 1.6m.
Scan max signal voltage 9+/-1V p-p.
Scan frequency: 130KHz.
Length breakage location: yes.
Analog / digital mode: yes.
PoE test range: DC 5-60V standard / non-standard PoE switch.
PoE voltage display: yes.
PSE type: standard: IEEE802.3af / IEEE802.3at; non-standard.
Voltage protection: DC 48V 5mA.
LCD display: 128x64 dot-matrix with backlight.
Max. emitter working current: <150mA.
Adjustable sensitivity: yes.
AC voltage detecting: yes.
Max. receiver working current: <100mA.
Remote control port: RJ45.
Manual and warranty card.
Cable adapters set.